Ubiquiti Networks AF-24 Guia do Utilizador descarregar pdf (Página 8)

Installation Requirements

• 17 mm wrench

• 13 mm socket wrench or driver

• Clear line of sight between airFiber radios

• Clear view of the sky for proper GPS operation

• Mounting location with < 0.5° displacement due to twist and

sway under wind loading

• Mounting point:

• At least 1 meter below the highest point on the structure

• For tower installations, at least 3 meters below the top of the

tower

• Ground wires – min. 8 AWG (10 mm

) and max. length: 1 meter.

As a safety precaution, ground the airFiber radios to grounded

masts, poles, towers, or grounding bars.

WARNING: Failure to properly ground your airFiber

units will void your warranty.

• (Recommended) 2 Outdoor GigE PoE surge protectors

Note: For guidelines about grounding and lightning

protection, follow your local electrical regulatory codes.

• Outdoor, shielded Category 5e (or above) cabling and shielded

RJ-45 connectors should be used for all wired Ethernet

connections. Category 6 is required for installations with long

cable runs (up to 100 m).

We recommend that you protect your networks from the

most brutal environments and devastating ESD attacks with

industrial-grade shielded Ethernet cable and shielded RJ-45

connectors from Ubiquiti Networks. For more details, visit

www.ubnt.com/toughcable

Installation Overview

We recommend that you configure your paired airFiber radios

before mounting. Below is an overview of the installation with

specific details on the following pages:

• Connect Power over Ethernet to the DATA port, and connect an

Ethernet cable between your computer and the CONFIG port.

• Configure device settings in the airFiber Configuration Interface.

airFiber® AF-24 Quick Start Guide

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 35 36

Sem comentários

Ubiquiti Networks AF-24 Guia do Utilizador Página 8